Owners Manual

Interior lights
Features and controls 5-91
5
1. Press and hold the 2 outer HomeLink
®
buttons for at least 10 seconds. The indi-
cator will change from continuous yellow
to rapidly flashing green.
2. Release both buttons.
3. HomeLink
®
is now in the train (or learn-
ing) mode and can be programmed at any
time beginning with “Programming a new
HomeLink
®
” step 1.
N00585400024
To reprogram a HomeLink
®
button, complete
the following.
1. Press and hold the desired HomeLink
®
button. Do not release the button.
2. The indicator light will begin to slowly
flash orange after 20 seconds. The Home-
Link
®
button can be released at this point.
Proceed with “Programming a new
HomeLink
®
” step 2.
N00585600026
Your HomeLink
®
system operates on a radio
frequency subject to Federal Communica-
tions Commission (FCC) Rules (For vehicles
sold in U.S.A.) and Industry Canada Rules
(For vehicles sold in Canada). This device
complies with Part 15 of the FCC Rules and
RSS- 210 of the Industry Canada Rules.
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
that may be received, including interfer-
ence that may cause undesired operation.
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. End Users must follow the spe-
cific operating instructions for satisfying RF
exposure compliance. This transmitter must
be at least 12 inches (20 cm) from the user
and must not be co-located or operating in
conjunction with any other antenna or trans-
mitter.
The term “IC:” before the certification/regis-
tration number only signifies that Industry
Canada technical specifications were met.
N00525301644
NOTE
 Do not hold for longer than 20 seconds.
Reprogramming a single
HomeLink
®
button
NOTE
 If you do not complete the programming of a
new device to the button, it will revert to the
previously stored programming.
For questions or comments, visit
www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the HomeLink
®
Hotline.
General information
CAUTION
 The transmitter has been tested and complies
with FCC and IC rules.
Changes or modifications not expressly
approved by the party responsible for com-
pliance could void the user’s authority to
operate the device.
Interior lights
NOTE
 Be aware that leaving the light illuminated
with the engine off may run the battery
down.
Never leave the vehicle without checking
that the light is off.
BK0249600US.book 91 ページ ２０１７年４月２０日 木曜日 午後１時３６分