Owners Manual

Replacement of light bulbs
Vehicle care and maintenance 9-33
9
N00943701569
1. Open the liftgate.
(Refer to “Liftgate” on page 5-27.)
2. Remove the screws (A) that hold the light
unit.
3. Move the light unit toward the rear of the
vehicle to unfix the notch (B) and pin (C).
4. Turn the socket counterclockwise to
remove it.
5. Remove the bulb from the socket as fol-
lows.
• Back-up light bulb
Pull the bulb out.
• Rear turn signal light bulb
Turn the bulb counterclockwise while
pressing in.
6. To install the bulb, perform the removal
steps in reverse.
Rear combination lights
D- Back-up light
E- Rear turn signal light
F- Rear side-marker light, and tail and
stop light (LED) - Do not touch the
socket because replacing this light is
carried out by an authorized Mitsubishi
Motors dealer or a repair facility of
your choice.
NOTE
 The rear side-marker light, and tail and stop
light use an LED instead of the bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
NOTE
 When mounting the lamp unit, align the
notch (G) and pin (H) on the lamp unit with
the clip (I) and hole (J) in the body.
Back-up light bulb Rear turn signal light
bulb
BK0249500US.book 33 ページ ２０１７年４月２０日 木曜日 午後４時１分