Service manual

IIC-102
4G6 ENGINE <1992> -
Crankshaft, Flywheel and Drive Plate
CRANKSHAFT, FLYWHEEL AND DRIVE PLATE
135 Nm
REMOVAL AND INSTALLATION
2 98ftJbs.
I I
18
27
ml19
11 Nm
8 ft.lbs.
98 ft.lbs.
17 6 ** 1
I 5*3 II **
135 Nm
98 ftlbs.
Removal steps
14. Drive plate*
I, Flywheel bolt
15. Crankshaft adapter*
2. Flywheel 16. Rear plate
3. Ball bearing*
17. Bell housing cover
4. Drive plate bolt**
18. Oil seal case
5. Adapter plate** 19. Gasket
6. Drive plate** $04 20. Oil separator
7. Crankshaft bushing**
*C4 21. Oil seal
8. Drive plate bolt 22. Bearing cap bolt
9. Adapter plate +B4 23. Bearing cap
10. Drive plate
&A4 24. Crankshaft bearing (lower)
11. Crankshaft bushing
25. Crankshaft
12. Drive plate bolt* +A4 26. Crankshaft bearing (upper)
13. Adapter plate* 27. Cylinder block
NOTE
*
: Rear wheel drive
**
: Front wheel drive
***
: SOHC
**** : DOHC
*****: DOHC Turbo for ECLIPSE
6EN0428
TSB Revision