Service manual

11 F-44
4G6 ENGINE <1993> - Timing Belt
Tensloner -
6EN055!
6EN015L
eJ4 OIL PUMP SPROCKET INSTALLATION
(1) Insert a Phillips screwdriver [shank diameter 8 mm (.31 in.)
shaft] through the plug hole on the left side of the cylinder
block to block the left silent shaft.
(2) Install the oil pump sprocket.
(3) Apply a proper amount of engine oil to the bearing surfaces
of the nuts.
(4) Tighten the nuts to the specified torque.
I)K+ TENSIONER INSTALLATION
(1) Hook the tensioner spring ends to the water pump body
projection and tensioner bracket.
(2) Move tensioner fully toward water pump and tighten the
bolt and tensioner spacer.
I)L4 AUTO TENSIONER INSTALLATION
(1) If the auto tensioner rod is in its fully extended position,
reset it as follows.
(2) Clamp the auto-tensioner in the vise with soft jaws.
Caution
The plug at the bottom of the auto tensioner protrudes.
Insert a plain washer as illustrated to prevent the plug
from being in direct contact with the vise.
(3) Push in the rod little by little with the vise until the set hole
@ in the rod is aligned with the hole @I in the cylinder.
(4) Insert a wire [1.4 mm (.055 in.) in diameter] into the set
holes.
(5) Unclamp the auto tensioner from the vise.
1 TSB Revision