Specifications

www.mivec.co.nz
4G9 ENGINE (E-W) -
Exhaust Manifold (GDI)
11A-6b-3
INSTALLATION SERVICE POINTS
"
A
A
EXHAUST MANIFOLD BRACKET INSTALLATION
(1) Slide the washers over the bolts with the chamfered side
toward the bolt.
(2) Install temporarily the exhaust manifold brackets A and
B as shown in the illustration.
(3) Check that both brackets are in close contact with the
bosses, and then tighten fully the bracket mounting bolts.
"
B
A
EXHAUST MANIFOLD BRACKET INSTALLATION
(1) The washers must be installed with the shear-drooped
side toward the bolts.
(2) Temporarily install the exhaust manifold bracket as shown
in t he illustration.
(3) Verify that the bracket is brought into close contact with
the boss on the exhaust manifold, then tighten the bolts
to the specified torque.
PWEE9502-E
E
Dec. 1998Mitsubishi Motors Corporation Added
Bracket A
Bracket B
Exhaust
manifold
Shear-droop
Exhaust
manifold
Bracket