Specifications

ENGINE <4G9-GDI> – Camshaft and Camshaft Oil Seal
11A-17
CAMSHAFT AND CAMSHAFT OIL SEAL
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
D Air Intake Hose and Resonance Tank Removal and
Installation (Refer to GROUP 15 – Air Cleaner and
Resonance Tank.)
D Timing Belt Removal and Installation
(Refer to P.11A-29.)
D Engine Coolant Draining and Supplying
(Refer to GROUP 14 – On-vehicle Service.)
D Intake Manifold Removal and Installation
(Refer to GROUP 15.)
D Fuel Pump (High Pressure) and Fuel Pressure
Regulator (High Pressure) Removal and Installation
(Refer to GROUP 13A.)
88 Nm
21–25 Nm
35 Nm
1
2
6
3
4
7
3.4 Nm
12
8
11
10
22 Nm
9
12–15 Nm
10–12 Nm
5
13
15
14
10–12 Nm
10–12 Nm
10–12 Nm
21–25 Nm
Apply engine oil to all
sliding parts during
installation.
16
Removal steps
1. Earth cable connection
2. Condenser
3. Rocker cover
4. Rocker cover gasket
5. Camshaft position sensor support
6. Camshaft position sensing cylinder
AA""DA 7. Camshaft sprocket
"CA 8. Camshaft oil seal
9. Idler pulley
10. Timing belt rear cover, upper (LH)
11. Timing belt rear cover, lower (RH)
12. Timing belt rear cover, upper (RH)
"BA 13. Beam camshaft cap
14. Beam camshaft cap gasket
15. Thrust case
"AA 16. Camshaft