Specifications

ENGINE <4G9-GDI> – Cylinder Head Gasket
11A-26
REMOVAL SERVICE POINTS
AA" POWER STEERING OIL PUMP AND BRACKET
ASSEMBLY REMOVAL
Remove the power steering oil pump and bracket assembly
from the engine with the hose attached.
NOTE
Place the removed power steering oil pomp and bracket
assembly in a place where it will not be a hindrance when
removing and installing the cylinder head assembly, and tie
it with a cord.
AB" CYLINDER HEAD BOLT REMOVAL
Use the special tool to loosen the bolts in two or three steps
in the order of the numbers shown in the illustration, and
then remove the bolts.
INSTALLATION SERVICE POINTS
"AA CYLINDER HEAD GASKET INSTALLATION
1. Wipe off all oil and grease from the gasket mounting
surface.
2. Install so that the shapes of the cylinder head holes match
the shapes of the respective cylinder head gasket holes.
"BA CYLINDER HEAD BOLT INSTALLATION
1. When installing the cylinder head bolts, the length below
the head of the bolts should be within the limit.
If it is outside the limit, replace the bolts.
Limit (A): 96.4 mm
2. The head bolt washer should be installed with the burred
side caused by tapping out facing upwards.
3. Apply a small amount of engine oil to the thread section
and the washer of the cylinder head bolt.
Intake side Front of engine
Exhaust side
MB991653
35108 2
17964
Head bolt
Burred side
Head bolt
washer
(Engine
oil)
Cylinder
head
A