User`s manual

ManualsBrandsMitsubishi ManualsComputer equipmentA8GT-50KBF

6.10 Bar Code Reader

6.10.1 Bar code reader types

6 - 27

OVERVIEW

SYSTEM

CONFIGURATION

PERFORMANCE

NAMES OF

THE PARTS AND

THEIR SETTINGS

ROUGH

PRE-OPERATION

PROCEDURE

HANDLING

MAINTENANCE AND

INSPECTION

EMC DIRECTIVE

6.10 Bar Code Reader

The bar code reader is used for writing data that is read with the bar code reader into the programmable con-

troller CPU.

Refer to the following manual for details of the bar code function.

• When GT Designer is used : Help function of GT Designer

• When GT Designer2 is used : GT Designer2 Version Reference Manual

6.10.1 Bar code reader types

The bar-code reader, which has been confirmed to operate properly by Mitsubishi Electric, can be used.

For the operation-confirmed models, refer to the separately available document "List of operation-confirmed

devices for GOT900 series" (Technical bulletin T10-0028).

When the document is necessary, please contact your local Mitsubishi representative.

If the bar-code reader used is not given in the document, it may not operate properly.

The above document can be viewed on the Mitsubishi Electric FA Network Service On World Wide, MEL-

FANSweb home page.

(MELFANSweb home page: http://wwwf2.MitsubishiElectric.co.jp/melfansweb/english/)

6.10.2 Connecting procedure

• Please note that the bar code reader cannot be used if the GOT is connected to the

MELSECNET/B or MELSECNET II.

• The power supply (5V DC) needs to be supplied from an AC-DC adapter or a corresponding

power module to the bar code reader.

• The RS-232C cable needs to be prepared by the user of this product.

For details of preparations of the cable, please refer to the ["List of operation-confirmed devices

for GOT900 series" (Technical bulletin T10-0028)]

1) To the RS-232C interface of the GOT, choose and

connect one from the following: the connector for the bar

code reader; the connector for the power supply module;

and the connector on the GOT for the RS-232C cable.

(The connecting method differs depending on the kind of

bar code reader that will be used.)

For A95 GOT

For A956WGOT