User`s manual

8
(2) System equipment
The following table indicates the system equipment needed for
connection of external I/O equipment.
Type
Image No. Applocation
GOT unit
External I/O
interface unit
External I/O equipment-connected
GOT
A956WGOT,
A95*GOT,
A85*GOT
A8GT-50KBF
Ten-key panel A8GT-TK
Operation panel*1
FP5-MD41-A
(Kanaden Corp. make),
FP5-MD41-B
(Kanaden Corp. make)
Connector terminal block conversion
unit*2
A6TBY36-E, A6TBY54-E
Connection cable between [GOT] and
[ten-key panel]*2*3
A8GT-C05TK(0.5m)
Connection cable between [GOT] and
[operation panel]*1*2*5
Connection cable
(Kanaden Corp. make)
Connection cable between [GOT] and
[connector terminal block conversion
unit]*2*5
A8GT-C30TB(3m)
Connection cable between [connector
terminal block conversion unit] and
[general-purpose I/O equipment]
(Refer to Section 5.1 and
fabricate on user side.)
Connection cable between [connector
terminal block conversion unit] and
[ten-key panel]
(Refer to A8GT-TK Numeric
Keypad Panel User's Manual
and fabricate on user side.)
Connection cable between [connector
terminal block conversion unit] and
[operation panel]*5
Connection cable (Kanaden
Corp. make)
*1: The operation panel and cable for input only may also be fabricated on user
side.
Refer to Section 5.2 for details of the fabricating method.
*2: 12/24VDC power must be supplied for external I/O units.
*3: The connection cable may also be fabricated on user side.
Refer to the A8GT-TK Type Numeric Keypad Panel User's Manual for
details of the fabricating method.
*4: The connection cable may also be fabricated on user side. Refer to Section
5.2 for details of the fabricating method.
*5: The operation panel and cables for I/O may also be fabricated on user side.
Refer to Section 5.1 for details of the fabricating method.