User`s manual

18
7. Installation Procedure
Install the unit to the GOT in the following procedure:
(1) Thread External I/O unit mounting screw holes in the control box or the
like. (2-
φ
3.5 mounting holes)
The External I/O unit’s GOT connection cable is 50cm long.
Install the External I/O unit within this distance so that the GOT-end
connector of the cable may be fitted into the GOT
’
s connector.
When mounting the External I/O unit on the back of control box door,
exercise care to avoid screw holes passing through the control box
surface.
(2) Tighten the mounting screws to the specified torque range 39 to 59N
.
cm.
(3) Plug the GOT side connector of the External I/O unit to the option unit of
the GOT.
To remove the unit, reverse the installation procedure.