User guide

Accessport Installation Page 11
Vehicle Identification
The Accessport will attempt to automatically determine the target vehicle for installation.
If the Accessport successfully identifies the vehicle:
Verify that the identified vehicle is correct and press [OK] to confirm.
If an error occurs:
Please refer to [TROUBLESHOOTING SECTION].
Map Selection
Once the Accessport determines the installation vehicle type, it will present a list of maps
from which to choose for installation. The Accessport reprograms the ECU with the
calibration data from the map file selected for installation. This is the calibration data that the
ECU will use by default if it is reset due to power loss. For this reason, it is important to
select the map file that most closely matches the modification level of the target vehicle at
the time of install.
If you are unsure about which map applies to your modification level, please see the map
notes and their requirements for the modifications that will best fit your vehicle.
Select a map and press [OK] to view detailed information about that map. After confirming
that the selected map is correct, press [OK] again to proceed, or press [CANCEL] to return
to the map selection list.
Save Stock ECU Program Data
The Accessport has the ability to save the stock ECU program data. However, it takes
approximately 15 minutes to complete. Pressing CANCEL will skip the process of saving the
stock data; pressing OK will proceed with saving the stock data. The stock data is used
during the uninstall process to return to stock. If the stock data is not saved, stock data
supplied with the Accessport will be used when the Accessport is uninstalled. There is no
disadvantage to skipping this step and using the stock data supplied with the Accessport.
WARNING!
If a previous installation of an Accessport is detected, you will be given the option
to overwrite it with a new installation. Be aware that the previous installation will
be permanently lost and unrecoverable. This detection may occur prior to saving
the stock ECU program data, in which case the ECU program data will not be
saved. In the case of a previous install, a stock ECU program supplied on the
Accessport will be used when you uninstall.
Revision 1.097 Jun 25, 2013