User guide

Accessport Installation Page 9
Getting Started
1. Insert the key into the vehicle's ignition and leave it in the OFF position.
2. Locate the vehicle's OBD-II port under the left side of the driver's side dash.
3. Connect device to the OBD-II port.
a) (Accessport Version 2 only):
• Connect the small end of the provided USB
cable to the mini-USB port on the back of the
OBD connector.
• Plug the large end of the USB cable into the
standard USB port on the underside of your
Accessport. At this point the Accessport will
power up and after a few moments present
the installation menu.
• (EVO III and EVO IX only) Plug the
white sub-connector of the OBD
dongle into the white connector
immediately to the left of the OBD-II
port under the dash. The white
connector must to be connected for
all operations.
Revision 1.097 Jun 25, 2013