User manual

6A1 ENGINE (E-W) -
Crankshaft, Cylinder Block, Flywheel and
Drive Plate
11A-15-4
"
C
A
OIL SEAL INSTALLATION
(1) Apply engine oil to oil seal lip.
"
D
A
APPLICATION OF OIL SEAL CASE
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
"
E
A
DRIVE PLATE BOLT / FLYWHEEL BOLT
INSTALLATION
(1) Remove all the remaining sealant from bolts and thread
holes of crankshaft.
(2) Apply engine oil to the flange of bolt.
(3) Apply engine oil into the thread holes of crankshaft.
(4) Apply specified sealant to the thread of bolts.
Specified sealant:
3M Nut Locking Part No. 4171 or equivalent
(5) Tighten the bolts to specified torque.
INSPECTION
CRANKSHAFT OIL CLEARANCE (PLASTIC GAUGE
METHOD)
(1) Remove oil from crankshaft journal and crankshaft
bearing.
(2) Install the crankshaft.
(3) Cut the plastic gauge to the same length as the width
of bearing and place it on journal in parallel with its axis.
(4) Install the crankshaft bearing cap carefully and tighten
the bolts to specified torque.
(5) Carefully remove the crankshaft bearing cap.
(6) Measure the width of the plastic gauge at its widest part
by using a scale printed on the plastic gauge package.
Standard value: 0.02 - 0.04 mm
Limit: 0.1 mm
PWEE9622
E
Feb. 1997Mitsubishi Motors Corporation
9EN0077
MB990938
MD998776
6AE0110
9EN0102
6AE0101
6AE0102