Instruction manual

13
FEATURES &
FUNCTIONS
PRECAUTIONS
SPECIAL
FEATURES &
UNPACKING
CONNECTIONS
BEFORE
OPERATION
TROUBLE-
SHOOTING
CLEANING
OTHERS
Holder
Print paper
Print paper
Holder
Insert
20cm
Cut
Cut Cut
Bobbin
without gear
Bobbin with
gear
Incorrect
INSTALLING MONOCHROME THERMAL PAPER
Put the supplied bobbins on the both sides of the thermal paper
roll.
NOTE
Set the bobbins as shown in the right figure. Make sure to put the bobbin on the
correct position.
Unroll the thermal paper about 20cm (8 inch) and cut it not to use
sticky part.
Remove the sticky part, dust, or fingerprints on the paper.
Cut both edges of the paper.
NOTE
Ink sheet is not needed for thermal printing.
The thermal paper setting is completed.
NOTE
Sheet cartridge error appears when an ink sheet is installed though the printer driver
selects thermal paper.
The error appears during data transfer and start of printing operation.
INSTALLING PRINT PAPER
Move the paper release lever toward the front of the printer as
shown by the arrow.
Insert the print paper in the position as shown right.
Place the gear to the right side.
To set the left side, press the holder in the unit to the left and insert the print paper roller.