User manual

EN-28
Menu operation
You can make various settings using the displayed menus.
INSTALLATION
OFF, MIRROR, INVERT, MIRROR INVERT
AUTO POWER ON ON, OFF
RESET ALL OK
AUTO POWER OFF
ON, OFF
ON, OFF
FEATURE
MENU POSITION 1 (Upper left), 2 (Lower right)
MENU DIMMER ON, OFF
IMAGE REVERSE
SPLASH SCREEN
BLUE, BLACKBACK COLOR
STANDARD, LOW
5
LAMP MODE
STANDARD, LOW
STANDBY MODE
KEYSTONE
AUTO, 4:3, 16:9, ZOOM1, ZOOM2, STRETCH, ANAMORPHIC1, ANAMORPHIC2ASPECT
DISPLAY INPUT , MENU ACCESS
PASSWORD FUNCTION
LANGUAGE
, English, Español, Deutsch, Français, Italiano, , , ,
Português
SIGNAL
INFORMATION
HORIZ. POSITION
HOLD
REMOTE POSITION
0 - 999
VERT. POSITION 0 - 999
FINE SYNC. 0 - 31
TRACKING
USER
0 - 9999
CLAMP POSITION 1 - 255
CLAMP WIDTH 1 - 63
LPF
ON, OFF
OVER SCAN

SHUTTER(L)
0 - 32
SHUTTER(U)
0 - 32
SHUTTER(RS)
0 - 95
SHUTTER(LS)
0 - 95
VERT. SYNC.
AUTO, OFF
*3
*3
*3
*3
*1 *4
*4
NETWORK PROJECTOR NAME
xxxxx..., SET
*4
*4
*4
*4
AUTO, VIDEO, FILMCINEMA MODE
*4
*4
*4 *5
*3
*3
*3
OFF
BEGIN 0 - 99
END 0 - 99
DHCP
IP ADDRESS
xxx. xxx. xxx. xxx, SET
COMPUTER INPUT
SYNC. TYPE
LAMP TIME (LOW)
INPUT
RESOLUTION
HORIZONTAL FREQUENCY
VERTICAL FREQUENCY
AUTO, RGB, YCBCR/YPBPR
AUTO, FRONT, REAR
OFF, 5 min, 10 min, 15 min, 30 min, 60 min
OK
OK
ON
UNLOCK OK
LOCK
*2
IMAGE
GAMMA MODE
USER1 , USER2
PICTURE MODE
CINEMA, VIDEO, 3D, ISF(DAY), ISF(NIGHT),
AV MEMORY1 , AV MEMORY2 , AV MEMORY3
COLOR 
TINT 
SHARPNESS 


3(#)
REFERENCE 2.0, 2.1(VIDEO), 2.2, 3D, 2.4
ADJUST MODE ALL, RED, GREEN, BLUE
NOISE REDUCTION
CTI
SETUP
CINEMA, 2.0, 2.1(VIDEO), 2.2, 3D, 2.4
*1
BrilliantColor™ ON, OFF
3D ON
OFF
*6
*1
*1
ADVANCED MENU
OK
AUTO, FRAME PACKING, SIDE BY SIDE, TOP AND BOTTOM
3D MODE
3D SYNC.
2D-3D CONVERSION
3D DEPTH
NORMAL, REVERSE
ON, OFF
1 - 10
SCREEN SIZE
16:9, CINEMA SCOPE (2.35:1)
VERTICAL LOCATION
6
FRAME RATE CONVERSION
OFF, TRUE FILM, TRUE VIDEO
F.R.C. LEVEL
1 - 5
AUTO IRIS
OFF, AUTO 1, AUTO 2, AUTO 3
ON, OFF
0 - 5
COLOR
RED, YELLOW, GREEN, CYAN, BLUE, MAGENTA
GAIN
-49 - 50
SATURATION
0
HUE
0
POSITION
RIGHT UP, LEFT DOWN
FULL/MONO
FULL COLOR, MONO COLOR
RESET
OK
AUTO, OFF
*7
HDMI INPUT
AUTO, ENHANCED, NORMAL, SUPERWHITE
COLOR MANAGEMENT
TRIGGER1(POWER)
ON, OFFTRIGGER2(ANAMO)
CROSS HATCH , WHITE , BLACK TEST PATTERN
CONTRAST 
BRIGHTNESS 
HIGH BRIGHTNESS, COOL, MEDIUM, WARM, 3D
USER
CONTRAST B
BRIGHTNESS R
BRIGHTNESS G
BRIGHTNESS B
CONTRAST R 0
0
0
0
0
0
REFERENCE COOL, MEDIUM, WARM
CONTRAST G
COLOR TEMP.
ON
COLOR SPACE WIDE, NORMAL
OFF
NETWORK PASSWORD OK
IP CONFIG OK
PJLink CERTIFICATION ON , OFF
ON , OFF
NETWORK RESET OK
xxx. xxx. xxx. xxx, SET
xxx. xxx. xxx. xxx, SET
SUBNET MASK
DEFAULT GATEWAY
MAC ADDRESS
xx-xx-xx-xx-xx-xx
*1: Not available with certain signals.
*2: Available only when the input signal is TV50, TV60, 480i, 576i or 1080i.
*3: Setting range differs depending on the input signals.
*4: Not available when the input signal is from the HDMI 1 or HDMI 2 terminal.
*5: Available only when the input signal is 480i, 480p, 576i, or 576p.
*6: Available only when the input signal is 480i, 480p, 576i, 576p, TV60 or TV50.
*7: Available only when RGB output is selected on the output device side.