Instruction manual

16
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
•
Flowchart
■ Flowchart for connection and settings
Installation example :
Connect the terminals on the back ; and set initial settings. Next, make an alarm recording using the timer function, and
using alarm list search, retrieve, playback, and copy the data.
Connection the terminals on the back
• Connection the terminal on the back.
See “■ Connnecting to CCTV camera, monitor, sensor, the electric power supply”, page 18.
• Connection the alarm recording.
See “■ Alarm Recording Connection”, page 18 and “■ Rear View” , page 8, 9.
The unit is booted.
Changing the initial menu settings
• Setting the present time and screen display.
See “<TIME DATE/DISPLAY SETTINGS>”, pages 24, 25.
• Setting the present time.
See “♦ TIME DATE ADJUST”, pages 11,12.
• Setting the display mode.
See “■ DISPLAY MODE”, page 24.
• Setting the audio recording.
See “■ AUDIO RECORDING”, page 38 and “■ Continuous recording time table”, page 82.
Setting the HDD (hard disk drive) mode
• Setting the repeat recording.
See “■ HDD REPEAT REC”, page 37.
• Setting the remain HDD capacity.
See “■ REMAIN HDD”, page 40.
• Setting the call out.
See “• HDD REMAIN”, page 40 and “• HDD FULL”, page 41.
• Setting the buzzer.
See “■ BUZZER”, pages 39, 40.
Changing the multiplexer function
• Changing the split4 screen and split9 screen setting.
See “■ SPLIT4 SCREEN SETTING”, page 28 and “■ SPLIT9 SCREEN SETTING”, page 28.
• Changing the sequence setting.
See “■ SEQUENCE SETTING”, pages 28, 29.
Setting other various functuon
• Changing the screen display mode.
See “■ CLOCK LOACTION SETTING”, page 24 and “■ DUPLEX MODE DISPLAY”, page 25.
• Setting the camera title/memo.
See “■ CAMERA TITLE/MEMO SETTING”, pages 24, 25 and “■ CAMERA DISPLAY”, page 24.
• Setting the unit status outputted.
See “♦ MODE OUT 1 ~ MODE OUT 4”, page 39.
Setting the motion detection
• Selecting the camera number.
See “■ SELECTION CAMERA NUMBER”, page 29.
• Settinig the active/inactive of detection function.
See “■ MOTION DETECTION”, pages 29, 30.
• Setting the detection area.
See “■ DETECTION MASK SETTING”, page 30.
• Setting the sensitivity.
See “■ SENSITIVITY”, page 30.
• Setting the minimum number of dots for starting the motion detection operation.
See “■ MOTION THRESHOLD”, pages 30, 31.