Instruction manual

18
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Connections
Y/C
1
MAIN
OFF
ON
AC IN ~
234 56789
1
4
RESET
RS-232C
23 56789
1
ALARM IN
2 3 4 5 6 7 8 9
CLOCK ADJ REC EMERGENCY RESERVED MODE OUT 1 MODE OUT 2 MODE OUT 3 MODE OUT 4 CALL OUT MAX 30mA DC 5V OUT GND
CAMERA OUT
RS-232C
RESET
CAMERA IN
INOUT
VIDEO OUT
MIC
GND
AUDIO
100V
MONITOR
POWER CORD
for U.K
for the Continent
To AUDIO IN terminal
To VIDEO OUT or
S(Y/C) OUT terminal
One of either codes
should be connected.
To VIDEO IN or
S(Y/C) IN terminal
To AUDIO OUT terminal
To CAMERA IN 1 terminal
CAMERA #1
Up to 9 cameras
Processing the connecting line
Connection on the ALARM IN
terminals and the I/O terminals
Compatible power lines
ø0.32 ~ ø0.65 mm (AWG 28 ~ 22)
Cut the designated area from the
electric wire’s outer covering
(vinyl portion).
5~7mm
To GND
terminal
To ALARM IN terminal
corresponds to the
CAMERA #.
SENSOR #1
To MIC
terminal
MICROPHONE
CAUTION
Connecting a coaxial transmission
camera wrong may damage the input
terminal. Be careful.
CAUTION
When a microphone is
connected to the MIC jack,
the MIC jack will be given
priority over the AUDIO IN
terminal.
ALARM SWITCH
1
ALARM IN
2 3 4 5 6 7 8 9
CLOCK ADJ REC EMERGENCY RESERVED MODE OUT 1 MODE OUT 2 MODE OUT 3 MODE OUT 4 CALL OUT CALL OUT GND MAX 30mA DC 5V OUT GND
RESET
RESET
INOUT
MIC
GND
AUDIO
Connections
■ Connecting to CCTV camera, monitor, sensor, the electric power supply
■ Alarm Recording Connection
Example : The diagram below shows an example of connection for alarm signals corresponding to camera number
1.