Instruction manual

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

Initial settings

Connections (continued)

/Initial settings

■ Connecting with an external recording device

This unit is equipped with video output (RCA) and audio

output (RCA) terminals on the front and S(Y/C) OUT, VIDEO

OUT (BNC) and AUDIO OUT (RCA) tereminals on the rear.

Video signals can be simultaneously outputted from the

video output terminal on the front and the VIDEO OUT/S

OUT terminals on the rear. In the same manner, audio sig-

nals can be outputted in simultaneously from the audio

output terminal on the front and AUDIO OUT terminal on

the rear. By connecting an analog video recorder to these

terminal, recorded contents can be copied.

■ Initializing device

In the <HDD CONFIGURATION> setting, device initializa-

tion and HDD REC mode selection can be performed. When

initializing the device, all device data is erased.

1. Set the MAIN switch on the rear of the unit to ON. When the

ACCESS indicator turns off, press the POWER button on the

front of the unit while holding down the REC/STOP button.

• “SETTING UP...” appears on the screen and the unit is

booted. When boot-up is completed, the <HDD

CONFIGURATION> screen appears.

• POWER button operation will not be accepted while the

ACCESS indicator is flashing. Press the POWER button after

the indicator turns off.

HDD

MASTER HDD(80GB)

SLAVE NONE

POWER OFF INITIALIZE

HDD REC MODE NORMAL

ALL HDD DATA WILL BE ERASED

2. Turn the JOG dial to display “INITIALIZE” and turn the

SHUTTLE ring clockwise.

• “SETTING UP...” appears on the screen and initialization

starts.

• When completed with initialization, the display returns to

the normal screen.

！

All data in the Alarm List will be deleted, and re-

cording will start from 00001.

To not perform initialization, select “POWER OFF”.