Instruction manual

ManualsBrandsMitsubishi ManualsMusical equipmentDX-TL800E

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

<MOTION DETECTION SETTINGS> (continued)

1. In the above “SELECTION CAMERA NUMBER”, select the

camera to activate/inactivate motion detection.

2. In “MOTION DETECTION”, display the desired setting and

turn the SHUTTLE ring clockwise.

• The setting is confirmed and flashing stops.

■ DETECTION MASK SETTING

The area to activate motion detection is set here. Any of

the 192 dotted detection areas displayed by splitting indi-

vidually loaded video to equal 16 X 12 pixel sizes can be

selected and set.

Definition of setting mark ( default : all areas “ & ”

(active)).

“

& ” : Area activated with motion detection.

“ • ” : Area inactivated with motion detection.

It is possible to set various areas per camera.

Example of screen setting

For the video loaded from the camera set in “SELECTION

CAMERA NUMBER” :

• Display “ & ” for the right half of the screen to activate

motion detection.

• Display “ • ” for the left half of the screen to inactivate

motion detection.

1. In “SELECTION CAMERA NUMBER” , select the camera

for setting the detection area.

2. Select “DETECTION MASK SETTING” and turn the

SHUTTLE ring clockwise.

• The dotted screen with detection areas is displayed and the

background of the most upper left dot turns red and flashes.

& & &&&&&&&&&& &&&&

3. Use the

, , and

buttons to select the dot to activate/

inactivate and turn the JOG dial clockwise.

• The “

& ” (active) setting changes to “ • ” (inactive) setting.

• & &&&&&&&&&& &&&&

& & &&&&&&&&&& &&&&

When pressing the SPLIT/SEQUENCE button,

all dots change to “ & ” (active). When pressing the

ZOOM button, all dots change to “ • ” (inactive).

4. Repeat step 3 to activate/inactivate all desired dots.

• • ••••••&&&& &&&&

5. Turn the SHUTTLE ring counterclockwise.

• The setting is confirmed and the display returns to the

<MOTION DETECTION SETTINGS> screen.

！

During set detection mask setting, other settings

are not accepted. To exit the menu screen during

setting, turn the SHUTTLE ring counterclockwise.

■ SENSITIVITY

The sensitivity of detection for changes in the loaded video

data is set. Video data is sampled every 0.6 seconds and

compared for each camera. The sensitivity setting is di-

vided into the 5 levels of brightness.

SELECTION CAMERA NUMBER

MOTION DETECTION OFF

DETECTION MASK SETTING

SENSITIVITY HIGH••<<<LOW

MOTION THRESHOLD 1

TEST MODE

Setting ( default : “HIGH • •

< < <

LOW” )

“HIGH • • • • < LOW”, “HIGH • • • < < LOW”,

“HIGH • • < < < LOW”, “HIGH • < < < < LOW”,

“HIGH < < < < < LOW”

Sensitivity increases as “<” increases from

“HIGH • • • • < LOW” to “HIGH < < < < < LOW”.

To detect the slightest changes, set to

“HIGH < < < < < LOW”. However, detection may

not operate properly due to flickering of fluorescent

lighting, etc.

1. Select the camera to set the sensitivity in “SELECTION

CAMERA NUMBER” ( see page 29).

2. Display the desired setting in “SENSITIVITY” and turn the

SHUTTLE ring clockwise.

• The setting is confirmed.

■ MOTION THRESHOLD

The minimum number of dots for starting the motion de-

tection operation from the number of active dots within the

detection area is set here. Motion detection operates when

change that exceeds the number of minimum dot set is

detected.