Operation Manual

6-4

For emergencies

OTE

● Open the terminal cover before connecting the jumper

cable to the positive terminal of the 12V starter battery.

(Refer to “Disconnection and connection” on page 7-16.)

● Use the proper cables suitable for the battery size.

Otherwise heat damage to the cables could result.

8. Connect one end of the other jumper cable to the nega-

tive (-) terminal of the booster battery (B), and then con-

nect the other end to the designated ground location of

the vehicle with the discharged battery (A) at the point

farthest from the battery.

9. Start the engine in the vehicle providing the boost. Let the

engine idle a few minutes, then start the electric motor

unit by turning the electric motor switch to the ON posi-

tion.

WARNING

● Make sure that the jumper cables and your clothing

are clear of the cooling fans and drive belts. Entan-

glement with the fans or belts can cause serious per-

sonal injury.

WARNING

● Be sure to follow the proper order when connecting

the batteries, of: →→→.

● Make sure that the connection is made to the cor-

rect designated location (as shown in the illustra-

tion) properly. If the connection is directly made to

the negative (-) terminal of the battery, the flamma-

ble gases from inside the battery might catch fire

and explode, causing personal injury.

● When connecting the jumper cables, do not connect

the positive (+) cable to the negative (-) terminal.

Sparks can make the battery explode.

BK0140800US.book 4 ページ２０１１年９月２９日　木曜日　午後３時２８分