Operation Manual

General information/Charging
1-31
1
Handling and storing the control box
N01202900015
N
OTE
● Use hook and a rope that can support the weight of the EV
charging cable, 8.8 lbs (4 kg) as shown in the figure
below.
● Make sure that the rope has no damage before use.
FCC Notice: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residen-
tial installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio commu-
nications.
However, these is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the use is encouraged to try to correct
the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
!
● Use the method shown below to help secure the con-
trol box and to prevent the plug from being pulled
halfway out of the socket during charging.
BK0140800US.book 31 ページ ２０１１年９月２９日 木曜日 午後３時２８分