Operation Manual

1-68
General information/Charging
1
The following
symbol blinks
when the power
supply/communi-
cation switch on
the MiEV Remote
is pressed.
● ERROR
symbol
● symbol
Blinks after about 1
second.
● Electrical noise source is present in
the vicinity of the MiEV Remote.
(e.g. personal computer)
● Electrical noise source is present
between the vehicle and the MiEV
Remote.
Move away from the noise source.
Blinks after about 10
seconds.
The MiEV Remote antenna is not
extended.
Extend the MiEV Remote antenna to communi-
cate.
Out of effective communication range.
(e.g. too far away from the vehicle, or
radio signal is interfered)
Move to the location where the system reaches
the effective communication range.
The electric motor switch is at the posi-
tion other than “LOCK” position.
Turn the electric motor switch to the “LOCK”
position.
● Electrical noise source is present in
the vicinity of the vehicle.
● Electrical noise source is present
between the vehicle and the MiEV
Remote.
Move away from the noise source.
12V starter battery is discharged. Charge or replace the 12V starter battery.
Refer to “Jump-starting” on page 6-2, “12V
starter battery” on page 9-8.
The below symbol blinks about 10 seconds
after the power/communication switch on
the MiEV Remote is pressed.
● ERROR symbol
Some errors occur while the system is in
processing.
Press the power/communication switch again.
Phenomena Cause Remedy
BK0140800US.book 68 ページ ２０１１年９月２９日 木曜日 午後３時２８分