MXZ-3C24NA3 Service Manual

OPERATING PROCEDURE PHOTOS/FIGURES
3. Removing the fan motor
(1) Remove the top panel, the service panel, and the front
panel (Refer to section 1).
(2) Disconnect the power supply cord and indoor/outdoor
connecting wires.
(3) Disconnect the connector of CNF1 on the outdoor control
P.C. board.
(4) Remove the propeller fan.
(5) Remove the fan motor.
NOTE: The propeller fan nut is a reverse thread.
148
(NA, NA2, NA3)
(NA4)
Photo 12
Photo 13
Lead wire of CN171
Lead wire of compressor
Notch
Screws of fixing parts of the heat sink
Photo 14
Propeller fan
Screws of the outdoor fan motor
Lead wire of
CN171
Lead wires of
compressor
Notch
OBH702M