Operation Manual

91-
Settings
To put a call on hold and switch from Call 1 to Call 2:
To set up a conference-call
You can set up a conference-call with up to 5 participants. This option is network/subscription
dependent.
During the conference-call, the following Options menu is available:
To end a conference-call:
Sending my ID
You can disable the sending of your own number on a call by call basis by adding #31# before
the number you are dialling. You can also ask your service operator to hide your mobile phone
number by default. Once hidden by your operator, you can show your number, on a call by call
basis, by entering *31# before the number you are calling.
To check the Sending my ID status:
To hide or show your ID:
Please contact your service provider for more information.
1 Whilst a call is in progress, a beep sounds to indicate a second incoming call.
Select Replace to take Call 2 and end Call 1, select Reject to refuse Call 2 or press the Call/
[Send] key to put Call 1 on hold and take Call 2.
Press the [End/Off] key to end Call 1 and press the [Call/Send] key to take Call 2.
2 Select Options then select Swap to get back to Call 1 and put Call 2 on hold.
1 Whilst two calls are in progress and a new call is received, select Options then Join or press
then press the [Call/Send] key to set up the conference-call. Repeat the action each time
a new call is received.
In compliance with European regulations, you are obliged to inform your correspondents before
recording a phone conversation.
You can set up and receive a new call during the conference-call. In these cases the conference-call is put on
hold.
OPTIONS DESCRIPTION
Speaker On/Off To activate/deactivate the hands free mode.
Auto-DTMF To type a new phone number and add this new correspondent to the
conference-call. If the Auto-DTMF option is deactivated, you cannot type in
a new phone number.
Private with To have a private conversation with one of the participants. During a private
conversation, the conference-call is put on hold.
Hold To put the conference-call on hold.
Retrieve To retrieve the conference-call if it is put on hold.
Mute/Unmute To mute/unmute the microphone.
End one To end one call.
End all To end the conference-call.
Record To record the conference-call up to 11min.
1 Press the [On/Off] key or select Options then End all to end the conference-call.
1
Press the [Menu/T9] key. Select Settings.
2 Select GSM Services.
3 Select Sending my ID.
4 Select Status. The request is launched and an information message displays the Sending
my ID status.
1
Press the [Menu/T9] key. Select Settings.
2 Select GSM Services.
3 Select Sending my ID.
4 Select My settings.
5 Select Hide my ID to prevent the mobile from sending your ID when making a call, select
Show my ID to allow the mobile to send your ID or select Preset to get back to the default
factory/operator setting.