User`s manual

122
4.3.5 Coincidence detection interrupt function
The coincidence detection interrupt function performs an interrupt request to the CPU module, and starts an interrupt
program when the count value matches with the specified value or range.
Note that this function can be used only when the coincidence output function is selected as the comparison output
setting value, and the normal mode is selected as the operation mode.
The comparison output setting value and the operation mode setting can be set in the switch setting.
Page 180, Section 6.2
(1) Interrupt factors
The QD65PD2 has the following ten interrupt factors, and eight of them correspond to coincidence output.
(2) Interrupt request setting method
In order to issue an interrupt request when interrupt factors (SI No.0 to 7) occur, set the coincidence output which
uses the interrupt request at Coincidence detection interrupt setting (Un\G2).
Page 66, Section 3.4.2 (3)
SI No. Interrupt factor Note
0 Coincidence detection of the coincidence output 1

1 Coincidence detection of the coincidence output 2
2 Coincidence detection of the coincidence output 3
3 Coincidence detection of the coincidence output 4
4 Coincidence detection of the coincidence output 5
5 Coincidence detection of the coincidence output 6
6 Coincidence detection of the coincidence output 7
7 Coincidence detection of the coincidence output 8
8 Cycle passing of CH1 periodic pulse counter function
Page 139, Section 4.9.1
9 Cycle passing of CH2 periodic pulse counter function