User`s manual

126
(3) Preset/replace function by the phase Z input terminal (Z1)
(a) Setting method of the preset/replace function by the phase Z input terminal (Z)
The preset/replace function by the phase Z input terminal (Z1) can be performed by meeting the set trigger
condition
• A trigger condition can be set at CH1 Z phase (Preset) trigger setting (Un\G1000.b0, b1)
• CH1 External preset/replace (Z Phase) request detection (X05) can be set in CH1 External preset/replace
(Z Phase) request detection setting (Un\G1000.b4).
For more details, refer to the following section.
Page 71, Section 3.4.2 (15)
(b) Operation example of the preset/replace function by the phase Z input terminal
The figure below shows an operation example with the setting as follows:
CH1 Z phase (Preset) trigger setting (Un\G1000.b0, b1): Rising (0)
CH1 External preset/replace (Z Phase) request detection setting (Un\G1000.b4): ON at detection (0)
0
2)
4)
3)
1)
100
2)
OFF
ON
OFF
ON
OFF
ON
OFF
ON
101666521
0
123 124 100 10110067
toto
Counter input pulse
CH1 Count enable command
(Y06)
CH1 Preset value
(Un\G1014, Un\G1015)
CH1 Preset/replace command
(Y03)
Phase Z input terminal
(Z1)
CH1 External preset/replace (phase Z)
request detection (X05)
CH1 External preset/replace (phase Z)
request detection reset command (Y05)
CH1 Present value
(Un\G1050, Un\G1051)
3)
OFF
ON
t *1
*1 t 2ms
t *1