User`s manual

ManualsBrandsMitsubishi ManualsComputer equipmentM557

151

152

153

154

155

156

157

158

159

160

157

CHAPTER 4 FUNCTION

4.15 Pulse Measurement Function

(6) Update timing of the measured values of pulses

CH1 Measured pulse value (function input terminal) (Un\G1222, Un\G1223) and CH1 Measured pulse value

(latch counter input terminal) (Un\G1242, Un\G1243) are updated every 1ms.

So when the measurement is done twice or more within 1ms, only the latest measured value is stored in the

buffer memories.

(7) Operation example of the pulse measurement function

The following figure shows an operation example of the pulse measurement function when Pulse ON width is set

to the pulse measurement setting.

The explanations in the table below are for the measurement with the function input terminal (FUNC1). The same

can be applied to the measurement with the latch counter input terminal (LATCH1) except the difference of the

input terminal, signal, and buffer memories.

XXX

AAA

YYY

ZZZ

1) 5)

4) 6)

OFF

CH1 Count enable command

(Y06)

Function input terminal

(FUNC1)

Latch counter input terminal

(LATCH1)

CH1 Pulse measurement start command

(function input terminal)

(Un\G1210)

CH1 Measured pulse value

(function input terminal)

(Un\G1222, Un\G1223)

CH1 Measured pulse value update flag

(function input terminal)

(Un\G1221)

CH1 Measured pulse value update

flag reset command

(function input terminal)

(Un\G1211)

CH1 Pulse measurement flag

(function input terminal)

(Un\G1220)

CH1 Pulse measurement start command