User`s manual

160
For the Coincidence output that is assigned as the PWM output terminal in CH1 PWM output assignment (Un\G1300), the
setting in Coincidence output condition setting (Un\G0) is disabled.
Even so, set any of 0
H
to 2
H
to Coincidence output condition setting (Un\G0).
(3) Setting of the output waveform
Set the output waveform by using CH1 On width setting (PWM output) (Un\G1302, Un\G1303) and CH1 Cycle
setting (PWM output) (Un\G1304, Un\G1305).
Note that the setting range varies depending on which Coincidence output is assigned as the PWM output
terminal.
*1 Set the value that is equal to or smaller than the one set to CH1 Cycle setting (PWM output) (Un\G1304, Un\G1305)
● ON width of the PWM output is calculated by inputting the duty ratio into the following formula:
• ON width of the PWM output = A cycle of the PWM output × Duty ratio(%) 100
● Given that output circuits or connected devices of the QD65PD2 do not affect the value, the margin of error (maximum) of
each setting value is calculated as shown below.
• Setting value of PWM output ON width (µs) × 100 (ppm) 1000000 + 0.1 (µs)
• Setting value of PWM output cycle (µs) × 100 (ppm) 1000000 + 0.1 (µs)
Setting item
PWM output
terminal
Setting contents Reference
CH1 On width setting (PWM
output) (Un\G1302, Un\G1303)
Coincidence output 1
or 2
Set ON width of the output pulse from 0 or in the
range of 10 to 10000000 (0.1µs per unit).
*1
Page 86, Section 3.4.2 (67)
Coincidence output 3
to 8
Set ON width of the output pulse from 0 or in the
range of 1000 to 10000000 (0.1µs per unit).
*1
CH1 Cycle setting (PWM
output) (Un\G1304, Un\G1305)
Coincidence output 1
or 2
Set the cycle of the output pulse in the range of 50
to 10000000 (0.1µs per unit).
Page 87, Section 3.4.2 (68)
Coincidence output 3
to 8
Set the cycle of the output pulse in the range of
5000 to 10000000 (0.1µs per unit).
CH1 On width setting (PWM output)
(Un\G1302, Un\G1303)
CH1 Cycle setting (PWM output)
(Un\G1304, Un\G1305)