User`s manual

167
CHAPTER 5 SETTINGS AND PROCEDURE BEFORE OPERATION
5
5.2 Procedure Before Operation
5.2 Procedure Before Operation
The figure below shows the steps before starting the QD65PD2 operation.
Start
Module mounting
Mount the QD65PD2 in a slot.
Wiring
Wire external devices to the QD65PD2.
Switch setting
Set the intelligent function module switches
with programming tool.
Configure initial setting and
auto refresh setting with GX Works2?
Yes
No
Configure initial setting?
Yes
Configure initial setting?
Yes
Initial setting
Create a sequence program for writing initial
values with the FROM/TO instructions.
Initial setting
Configure initial setting with GX Works2.
Configure auto refresh setting?
No
No
Yes
Auto refresh setting
Configure auto refresh setting with GX Works2.
Programming
Create a counter processing program without
the FROM/TO instructions and check if
the program works correctly.
Programming
Create a counter processing program with
the FROM/TO instructions and check if
the program works correctly.
Operation
No
Page 180, Section 6.2,
Page 276, Appendix
2.1 (2)
Page 185, Section 6.3
Page 188, Section 6.4