User`s manual

185
CHAPTER 6 SETTINGS
6
6.3 Parameter Setting
6.3 Parameter Setting
Set the parameters for each channel.
(1) Setting method
Open "Parameter".
1. Start "Parameter" in the project window.
Project window [Intelligent Function Module] Module name [Parameter]
2. Double-click the item to be set and enter the setting value.
• Item to be selected from the pull-down list
Double-click the item to be set to display the pull-down list, and select the item.
• Item to be input in a text box
Double-click the item and enter a value.
Item Setting value Reference
Basic
setting
Coincidence output condition setting 
Page 109, Section 4.3.2
Coincidence output 1 to 8
• 0: Coincidence output (default value)
• 1: In-Range Output
• 2: Not-In-Range Output
Preset/replace setting at coincidence
output

Page 116, Section 4.3.3
Coincidence output 1
• 0: Not preset (default value)
• 1: Preset
Coincidence output 2
Coincidence detection interrupt setting 
Page 122, Section 4.3.5
Coincidence output 1 to 8
• 0: Not used
•1: Use
Item to be selected from the pull-down list
Item to be input in a text box