User`s manual

186
Basic
setting
Point setting (coincidence output 1)
-2147483648 to 2147483647 (default value: 0)
Page 109, Section 4.3.2
•••
Point setting (coincidence output 8)
Lower limit value (coincidence output 1)
-2147483648 to 2147483647 (default value: 0)
Upper limit value (coincidence output 1)
•••
Lower limit value (coincidence output 8)
Upper limit value (coincidence output 8)
Cam switch function (coincidence output
1 to 8)

Page 118, Section 4.3.4
Step type
• 0: Start from output status OFF (default value)
• 1: Start from output status ON
Number of steps 0 to 16 (default value: 0)
Step No.1 setting
-2147483648 to 2147483647 (default value: 0)
•••
Step No.16 setting
Z phase setting 
Page 126, Section 4.4 (3)
Z phase (Preset) trigger setting
•0: Rising
• 1: Falling
• 2: Rising+Falling
• 3: During ON
External preset/replace (Z phase)
request detection setting
• 0: ON at detection (default value)
• 1: Not ON at detection
Periodic interrupt setting
• 0: Not used
•1: Use
Page 139, Section 4.9.1
Ring counter lower limit value
-2147483648 to 2147483647 (default value: 0) Page 104, Section 4.2.2
Ring counter upper limit value
Preset value -2147483648 to 2147483647 (default value: 0) Page 125, Section 4.4
Time unit setting (sampling counter/
periodic pulse counter)
• 0: 1ms (default value)
• 1: 10ms
Page 133, Section 4.8
Page 136, Section 4.9
Cycle setting (sampling counter/periodic
pulse counter)
1 to 65535 (default value: 1)
Time unit setting (frequency
measurement)
• 0: 0.01s (default value)
• 1: 0.1s
•2: 1s
Page 146, Section 4.13
Moving average count (frequency
measurement)
1 to 100 (default value: 1)
Time unit setting (rotation speed
measurement)
• 0: 0.01s (default value)
• 1: 0.1s
•2: 1s
Page 150, Section 4.14
Moving average count (rotation speed
measurement)
1 to 100 (default value: 1)
Number of pulses per rotation 1 to 8000000 (default value: 1)
Item Setting value Reference