User`s manual

190
● When CH1 Count enable command (Y06) is OFF, the present value cannot be replaced with the preset value; "Count" in
the "Preset" dialogue box shows "Disable".
● While CH1 External preset/replace (Z Phase) request detection (X05) is ON, the preset/replace function cannot be
performed; "External Preset Request" in the "Preset" dialogue box shows "Detected (Unacceptable)". For the case
above, clicking button in the "Preset" dialogue box turns off CH1 External preset/replace (Z Phase)
request detection (X05). Then, the present value can be replaced with a preset value.
● The preset value changed in "Change Preset Value" is changed back to the preset value set in "Parameter" when the
CPU module is reset or at the rising state (OFF ON) of the power.
To keep the change made on the preset value, set the change from "Preset value" in "Parameter".
5. After confirming that the preset value is reflected on
"Preset Value", click .

6. Click .

7. The value on "Preset Value" is reflected on
"Current Value".