User`s manual

195
CHAPTER 7 PROGRAMMING
7
7.1 Using the Module in a Standard System Configuration 7.1.1 Program example when the parameters of the intelligent function module are used
7.1.1 Program example when the parameters of the intelligent
function module are used
(1) Devices used by the user
Device Description
D0. D1 Present value
Devices in which data is written by auto
refresh
D2, D3 Latch count value (counter function selection)
D4, D5
Latch count value (latch counter input
terminal)
D6, D7 Sampling count value
D8. D9 Periodic pulse count, difference value
D10, D11 Periodic pulse count, present value
D12, D13 Periodic pulse count value update check
D14 Overflow/underflow detection flag
D16
Counter value greater/smaller (coincidence
output)
D32 Error status
D33
Error code latch (latest error code)
*1
D35 Warning status
D36
Warning code latch (Latest warning code)
*3
D44, D45 Measured frequency value
D54, D55 Measured rotation speed value
D62, D63
Measured pulse value (function input
terminal)
D72, D73
Measured pulse value (latch counter input
terminal)
D34
Detected error code
*2
D37
Detected warning code
*4
D130, D131 stores the periodic pulse count difference value
D132, D133 stores the periodic pulse count present value
D134, D135 stores the periodic pulse count update check value
X0 Module ready
QD65PD2(X/Y00 to X/Y1F)
X1
Operating condition settings batch-changed
signal
X8
CH1 Cam switch function execution/PWM
output signal
X10 Coincidence output 1 signal
X11 Coincidence output 2 signal
Y2 CH1 Coincidence output enable command
Y3 Preset/replace command
Y6 CH1 Count enable command
Y7
CH1 Selected counter function start
command
Y8
CH1 Cam switch function/PWM output start
command
Y10 Reset command (coincidence output 1)