User`s manual

199
CHAPTER 7 PROGRAMMING
7
7.1 Using the Module in a Standard System Configuration 7.1.1 Program example when the parameters of the intelligent function module are used
*1 Set only when using the coincidence output function.
*2 Set only when using the coincidence detection interrupt function.
*3 Set only when using the cam switch function.
*4 Set only when using the periodic interrupt function.
*5 Set only when using the ring counter function.
*6 Set only when using the sampling counter function or periodic pulse counter function.
*7 Set only under the frequency measurement mode.
*8 Set only under the rotation speed measurement mode.
*9 Set only under the pulse measurement mode.
*10 Set only under the PWM output mode.
PWM output assignment
*10
Select any from coincidence output 1 to 8 to output the
PWM wave form.

PWM output assignment (coincidence
output 1)
Set whether to assign the coincidence output 1 to PWM
output.
1: Assignment
ON width setting (PWM output) Set the ON time of output pulses for PWM output. 100.0µs
Cycle setting (PWM output) Set the cycle time of output pulses for PWM output. 200.0µs
Item Description Setting value