User`s manual

201
CHAPTER 7 PROGRAMMING
7
7.1 Using the Module in a Standard System Configuration 7.1.1 Program example when the parameters of the intelligent function module are used
*1 Set only when using the coincidence output function.
*2 Set only when using the latch counter function (counter function selection).
*3 Set only when using the latch counter function by latch counter input terminal.
*4 Set only when using the sampling counter function or periodic pulse counter function.
*5 Set only when using the periodic pulse counter function.
*6 Set only under the frequency measurement mode.
*7 Set only under the rotation speed measurement mode.
*8 Set only under the pulse measurement mode.
(4) Program example under the normal mode
(a) Initial setting program
This program is not necessary in this program example since the initial setting is set with the parameter setting
in Page 197, Section 7.1.1 (2).
(b) Common program
(c) Counter function program
• program for the preset/replace function
• program for the latch counter function by counter function selection
• program for the count disable function
Latest error code Stores the error code of the error in process. D33
Latest warning code Stores the warning code of the warning in process. D36
Item Description Setting value
Turn on CH1 Count enable command.
Turn off CH1 Count enable command.
Turn on CH1 Preset/replace
command.
Turn on CH1 Selected counter function
start command.
Turn on CH1 Selected counter function
start command.