User`s manual

203
CHAPTER 7 PROGRAMMING
7
7.1 Using the Module in a Standard System Configuration 7.1.1 Program example when the parameters of the intelligent function module are used
(5) Program example of the frequency measurement mode
(6) Program example of the rotation speed measurement mode
(7) Program example of the pulse measurement mode
(8) Program example of the PWM output mode
Turn on CH1 Count enable command.
Turn off CH1 Count enable command.
Turn on CH1 Count enable command.
Turn off CH1 Count enable command.
Turn on CH1 Count enable command.
Turn off CH1 Count enable command.
CH1 Pulse measurement start
command (function input terminal)
: Measured (1
H)
CH1 Pulse measurement start
command (function input terminal)
: Not measured (0
H)
CH1 Pulse measurement start
command (latch counter input terminal)
: Not measured (0
H)
CH1 Pulse measurement start
command (latch counter input terminal)
: Measured (1
H)
Turn on CH1 Cam switch function/
PWM output start command.