User`s manual

213
CHAPTER 7 PROGRAMMING
7
7.2 When Using the QD65PD2 in a MELSECNET/H Remote I/O net
7.2 When Using the QD65PD2 in a MELSECNET/H Remote
I/O net
This section describes program examples and the system configuration when using the QD65PD2 in a
MELSECNET/H remote I/O net.
Note that the examples in this section use only CH1.
(1) System configuration
The following figure shows a system configuration example when using the QD65PD2 in a MELSECNET/H
remote I/O net.
(2) Switch setting
For the switch setting, refer to the procedure in Page 216, Section 7.2 (6)
(3) Initial setting of the program
The initial setting of the program is the same as the program example used in a standard system configuration.
Page 193, Section 7.1 (3)
(4) Configuration of program examples
Program configurations are described below.
(a) Program configuration under the normal mode
A program configuration under the normal mode is the same as the program example used in a standard
system configuration.
Page 194, Section 7.1 (4) (a)
(b) Program configuration under a mode other than the normal mode
Program examples under a mode other than the normal mode operate in a single-program example.
Remote I/O station
(station number: 1)
QJ71LP21-25 (X/Y0 to X/Y1F)
QX10 (X20 to X2F)
QD65PD2 (X/Y1020 to X/Y103F)
QY10 (Y1010 to Y101F)
QX10 (X1000 to X100F)
QJ72LP25-25
Network number 1
Remote master station
(station number: 0)
QX10 (X30 to X3F)
QY10 (Y40 to Y4F)
QCPU