User`s manual

214

If error or warning processing is required for a program example under a mode other than the normal mode, take the

following measures.

● When using the parameters of the intelligent function module (mode other than the pulse measurement mode)

• Add the common program of the normal mode shown in the same section to each program.

• Add the error/warning reset program of the normal mode shown in the same section before the END instruction of

each program.

*1 If error or warning processing is required for a program example under the pulse measurement mode, add the

error/warning reset program of the normal mode shown in the same section before the MCR instruction.

● When not using the parameters of the intelligent function module

Add the error/warning reset program of the normal mode shown in the same section before the MCR instruction of each

program.

(5) Master station setting

1. Create a project using GX Works2.

Select "QCPU(Q mode)" for "PLC Series" and the CPU module to be used for "PLC Type".

[Project] [New...]

2. Open the network parameter setting window and set parameters as shown below.

Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]