User`s manual

221
CHAPTER 7 PROGRAMMING
7
7.2 When Using the QD65PD2 in a MELSECNET/H Remote I/O net
7. Open the auto refresh window and set parameters as shown below.
When creating a program without using the parameters of the intelligent function module, skip
this procedure.
Project window [Intelligent Function Module] [QD65PD2] [Auto_Refresh]
Item Description Setting value
Counter value greater/smaller (coincidence
output)
*1
stores the relationship (greater or smaller) between the point
setting of coincidence output 1 to 8 and the present value.
W16
Error status Set the device that stores the error status of each channel. W32
Warning status Set the device that stores the warning status of each channel. W35
Present value Set the device that stores the present value. W0
Latch count value *2
Set the device that stores the latch count value when the latch
counter function (counter function selection) is used.
W2
Latch count value (latch counter input
terminal)
*3
Set the device that stores the latch count value by the latch
counter input terminals (LATCH1, LATCH2).
W4
Sampling count value *4
Set the device that stores the sampling count value when the
sampling counter function is used.
W6
Periodic pulse count, difference value
*5
Set the device that stores the periodic pulse count difference
value when the periodic pulse counter function is used.
W8
Periodic pulse count, present value
Set the device that stores the periodic pulse count present
value when the periodic pulse counter function is used.
W10
Periodic pulse count value update check
Set the device that stores the periodic pulse count update
check value when the periodic pulse counter function is used.
W12
Overflow/underflow detection flag
Set the device that stores the detected result of
overflow/underflow error when the linear counter function is
used.
W14
Measured frequency value *6
Set the device that stores the periodic pulse count value when
the periodic pulse counter function is used.
W44
Measured rotation speed value *7
Set the device that stores the measured value of the rotation
speed when the rotation speed measurement function is used.
W54