User`s manual

226
(3) Program example under the normal mode
(a) Initial setting program
This program is not necessary in this program example since the initial setting is set in Page 216, Section 7.2
(6).
(b) Common program
*1 Add the following MCR instruction at the end of the program.
(c) Counter function program
• program for the preset/replace function
• program for the latch counter function by counter function selection
• program for the count disable function
Baton pass status check of the master
station
Data link status check of the master
station
Baton pass status check of a remote
I/O station
Cyclic transmission status check of a
remote I/O station
Parameter communication status
check of a remote I/O station
Master module status check
*1
Turn on CH1 Count enable command.
Turn off CH1 Count enable command.
Turn on CH1 Preset/replace command.
Turn off CH1 Preset/replace command.
Turn on CH1 Selected counter
function start command.
Turn off CH1 Selected counter
function start command.
Turn on CH1 Selected counter
function start command.
Turn off CH1 Selected counter
function start command.