User`s manual

229
CHAPTER 7 PROGRAMMING
7
7.2 When Using the QD65PD2 in a MELSECNET/H Remote I/O net 7.2.1 Program example when the parameters of the intelligent function module are used
(6) Program example of the pulse measurement mode
(7) Program example of the PWM output mode
CH1 Pulse measurement start
command (function input terminal)
: Measured (1
H)
CH1 Pulse measurement start
command (latch counter input
terminal): Measured (1
H)
Turn off CH1 Count enable command.
CH1 Pulse measurement start
command (function input terminal)
: Not measured (0
H)
CH1 Pulse measurement start
command (latch counter input
terminal): Not measured (0
H)
Turn on CH1 Count enable command.
Baton pass status check of the master
station
Data link status check of the master
station
Baton pass status check of a remote
I/O station
Cyclic transmission status check of a
remote I/O station
Parameter communication status
check of a remote I/O station
Master module status check
*1
Turn on CH1 Cam switch function/
PWM output start command.