User`s manual

234
(2) Program example under the normal mode
(a) Initial setting program
*2
*3
*5
*4
Baton pass status check of the master
station
Master module status check
*1
Data link status check of the master
station
Baton pass status check of a remote
I/O station
Cyclic transmission status check of a
remote I/O station
Preset/replace setting at coincidence
output: Not preset
Point setting (coincidence output 1)
: 1000
Lower limit value request (coincidence
output 2): 1000
Upper limit value request (coincidence
output 2): 2000
CH1 Cycle setting (sampling counter/
periodic pulse counter): 1ms
CH1 Time unit setting (sampling
counter/periodic pulse counter)
: 1000ms
CH1 Ring counter lower limit value
: -5000
CH1 Ring counter upper limit value
: 5000
CH1 Preset value setting: 100
Coincidence output comparison
condition setting
coincidence output 1: coincidence output
coincidence output 2: in-range output
Parameter communication status
check of a remote I/O station
Cam switch function, step type
(coincidence output 1): Start from
output status OFF
Cam switch function, number of steps
(coincidence output 1): 6
Cam switch function, step No.1 setting
(coincidence output 1): 100
Cam switch function, step No.2 setting
(coincidence output 1): 250
Cam switch function, step No.3 setting
(coincidence output 1): 400
Cam switch function, step No.4 setting
(coincidence output 1): 550
Cam switch function, step No.5 setting
(coincidence output 1): 700
Cam switch function, step No.6 setting
(coincidence output 1): 850