User`s manual

235
CHAPTER 7 PROGRAMMING
7
7.2 When Using the QD65PD2 in a MELSECNET/H Remote I/O net 7.2.2 Program example when the parameters of the intelligent function module are not used
*1 Add the following MCR instruction at the end of the program.
*2 Set only when using the coincidence output function.
*3 Set only when using the cam switch function.
*4 Set only when using the ring counter function.
*5 Set only when using the sampling counter function or periodic pulse counter function.
(b) Common program
Turn on Operating condition settings
batch-change command.
Turn off Operating condition settings
batch-change command.
CH1 Present value is stored.
Turn off CH1 Count enable
command.
Turn on CH1 Count enable
command.