User`s manual

247
CHAPTER 7 PROGRAMMING
7
7.2 When Using the QD65PD2 in a MELSECNET/H Remote I/O net 7.2.2 Program example when the parameters of the intelligent function module are not used
Turn on CH1 Count enable command.
CH1 Pulse measurement (function
input terminal) start command
: Measured (1
H)
CH1 Pulse measurement (function
input terminal) start command: Not
measured (0
H)
CH1 Pulse measurement (latch
counter input terminal) start command
: Measured (1
H)
CH1 Pulse measurement (latch
counter input terminal) start command
: Not measured (0
H)
CH1 Pulse measured value (function
input terminal) is read.
CH1 Pulse measurement update flag
reset command (function input
terminal): Reset (1
H)
CH1 Pulse measurement update flag
reset command (function input
terminal): Reset (1
H)
Turn off CH1 Count enable command.