User`s manual

33
CHAPTER 3 SPECIFICATIONS
3
3.3 I/O Signals to the CPU Module 3.3.1 List of I/O signals
(2) The list of output signals (Direction of signals: CPU module to QD65PD2)
*1 This signal is enabled while it is ON on the condition that the count disable function or the periodic pulse counter function
is selected.
The signal is enabled at its rise time (OFF to ON) on the condition that the latch counter function or the sampling counter
function is selected.
The signal is disabled on the condition that the count disable/preset/replace function or the latch counter/preset/replace
function is selected.
● The reserved signals above are used by the system and not available for users. If they are used (turned on and off) by
users, the performance of the QD65PD2 cannot be guaranteed.
● The illustration meanings of the operation timing are described below.
The signal is enabled while it is ON. 2ms or more are required for ON time.
The signal is enabled at its rise time (OFF to ON). 2ms or more are required for ON time or OFF time.
I/O
number
Signal name
Operation
timing
I/O
number
Signal name
Operation
timing
Y00 Reserved - Y10 Reset command (coincidence output 1)
Y01
Operating condition settings batch-
change command
Y11 Reset command (coincidence output 2)
Y02
CH1
Coincidence output enable
command
Y12 Reset command (coincidence output 3)
Y03 Preset/replace command Y13 Reset command (coincidence output 4)
Y04 Count down command Y14 Reset command (coincidence output 5)
Y05
External preset/replace (Z Phase)
request detection reset command
Y15 Reset command (coincidence output 6)
Y06 Count enable command Y16 Reset command (coincidence output 7)
Y07
Selected counter function start
command
*1
Y17 Reset command (coincidence output 8)
Y08
Cam switch function/PWM output
start command
Y18 General output 1
Y09
CH2
Coincidence output enable
command
Y19 General output 2
Y0A Preset/replace command Y1A General output 3
Y0B Count down command Y1B General output 4
Y0C
External preset/replace (Z Phase)
request detection reset command
Y1C General output 5
Y0D Count enable command Y1D General output 6
Y0E
Selected counter function start
command
Y1E General output 7
Y0F
Cam switch function/PWM output
start command
Y1F General output 8