User`s manual

40
(5) CH1 External preset/replace (Z Phase) request detection reset command (Y05)
• Tune on this signal to turn off CH1 External preset/replace (Z Phase) request detection (X05).
• A count value cannot be replaced with the preset value while CH1 External preset/replace (Z Phase) request
detection (X05) is ON.
• For details on the preset/replace operation, refer to the following:
Page 35, Section 3.3.2 (3)
(6) CH1 Count enable command (Y06)
• Turn on this signal to count pulses.
• The count is done as below in 1 multiple of 1 phase.
(7) CH1 Selected counter function start command (Y07)
• Turn on this signal to perform the selected counter functions.
• The count is done as below with the latch counter function being selected.
(8) CH1 Cam switch function/PWM output start command (Y08)
• Turn on this signal to execute the cam switch function.
• Turn on this signal to start PWM output.
A
B
CH1 Count enable command
(Y06)
CH1 Present value
(Un\G1050, Un\G1051)
ON
210
*1 t 2ms
031
CH1 Selected counter
function start command
(Y07)
04123
t *1 t *1
Operation by the QD65PD2
OFF
ON
OFF
ON
CH1 Present value
(Un\G1050, Un\G1051)
CH1 Latch count value
(Un\G1052, Un\G1053)