User`s manual

66
(3) Coincidence detection interrupt setting (Un\G2)
• Use this memory when "Coincidence Output" is selected in the "Comparison output setting value" in the
switch setting.
• Select whether coincidence detection interruption is executed or not and set the values of either 1: Interrupt
or 0: Not interrupt.
• For details on Coincidence output 1 to 8 and corresponding interrupt factors, refer to the following:
Page 122, Section 4.3.5
• Assign the interrupt factors to interrupt pointers in the CPU module before executing the coincidence
detection interruption. Failure to do so may cause an error in the CPU module.
• The setting values are enabled by turning off and on Operating condition settings batch-change command
(Y01).
• The default values set to Coincidence output 1 to 8 are 0: Not interrupt.
(4) Point setting (coincidence output 1 to 8) (Un\G100 to Un\G115)
• When the values set to these buffer memories are matched to the count value, signals are output.
• Use these memories on the condition that the bits corresponding to Coincidence output 1 to 8 in
Coincidence output condition setting (Un\G0) are set to 0: Coincidence output. Don't use the memories
when the bits are set to either 1: In-range output or 2: Not-in-range output.
• The setting range is between -2147483648 and 2147483647 in 32-bit signed binary format.
• The setting values are enabled by turning off and on Operating condition settings batch-change command
(Y01), or by setting corresponding Setting change request (coincidence output 1 to 8) (Un\G180 to
Un\G187) to 1
H
: Requested.
• The default values are 0.
(5) Upper/lower limit value (coincidence output 1 to 8) (Un\G120 to Un\G151)
• Use these memories to set the upper and lower limit value of the count range for the count value
comparison.
• Use these memories on the condition that the bits corresponding to Coincidence output 1 to 8 in
Coincidence output condition setting (Un\G0) are set to either 1: In-range output or 2: Not-in-range output.
Don't use the memories when the bits are set to 0: Coincidence output.
• The setting range is between -2147483648 and 2147483647 in 32-bit signed binary format.
• The setting values are enabled by turning off and on Operating condition settings batch-change command
(Y01), or by setting corresponding Setting change request (coincidence output 1 to 8) (Un\G180 to
Un\G187) to 1
H
: Requested.
• The default values are 0.
b15
0
b14
0
b13
0
b12
0
b11
0
b10
0
b9
0
b8
0
b7 b6 b5 b4 b3 b2 b1 b0
Fixed to 0.
0: Not interrupt
1: Interrupt
Coincidence
output 1
Coincidence
output 8
Coincidence
output 2
Coincidence
output 7
Coincidence
output 6
Coincidence
output 5
Coincidence
output 4
Coincidence
output 3