Service manual

46
PHOTOS
3. Removing the outdoor fan motor
(1) Remove the cabinet. (Refer to 1)
(2) Disconnect the connector to remove the clamp of fan motor
lead wire.
(3) Remove the propeller nut and remove the propeller.
(4) Remove screws securing the fan motor.
4. Removing the compressor
(1) Remove the cabinet. (Refer to 1)
(2) Remove the soundproof felt.
(3) Remove the terminal cover on the compressor.
(4) Disconnect lead wires from the glass terminal of the com-
pressor.(Refer to 2)
(5) Release gas from the refrigerant circuit.
(6) Disconnect the welded part of the discharge pipe.
(7) Disconnect the welded part of the suction pipe.
(8) Remove nuts securing the compressor.
(9) Remove the compressor.
NOTE:
● Before using a burner, purge gas from the pipes until the pres
sure gauge shows 0 Mpa (0 O/F).
● Use the burner under the condition that gas can be released
even when the inner pressure rises by heat.
Photo 5
Glass
terminal
Discharge
pipe
Suction
pipe
Nuts
Photo 4
Clamp
Connector
Propeller
OPERATING PROCEDURE
Propeller nut
OB270--2.qxp 4/13/01 3:04 PM Page 46