User`s manual

1 - 4
MELSEC-Q
1. OVERVIEW
(5) Setting of optimum positioning data without complicated calculation
Positioning data can be set by sub arc setting and automatic axis speed setting.
Sub arc setting generates from the specified two linear interpolation control data
the circular interpolation control data in which the angle between two linear paths
is converted into a circular arc (curve) path.
Sub axis speed setting calculates the axis speed (command speed) from the
operation time, travel, acceleration/deceleration time and motor specifications.
[Sub arc] [Speed of axis setting]
These functions allow the optimum positioning data to be set without complicated
calculation and advance measurement.
(6) Ease of migration from AD75
You can read and use the data created on A series SW1IVD-AD75P-E and
SW0D5C-AD75P-E.
Valuable data is not wasted and can be utilized for QD75.
Open another format file.
Existing data created
on SW D5C-AD75P-E
SW D5C-QD75P-E
SW D5C-AD75P-E
(7) Versatility by compatibility with RS-232 and USB
If the personal computer does not have a free serial port, connection can be
made from the USB connector.
Especially for a notebook computer having a few serial ports, there are no
restrictions due to shortage of ports.
and
RS-232 USB