User`s manual

Index - 1
INDEX
[2]
2-axis interpolation control
assisting the setting of................................ 8- 6
simulation of............................................... 8-10
trace of ..................................................... 11-33
[A]
active project .........................................................
5- 2, 6- 7, 12, 13, 9- 1, 4, 10-21,11-1, 3, 4, 14, 23
all axis stop................................................... 10- 1
application
ending ........................................................ 4-11
starting ....................................................... 4-10
assistance
setting axis speed....................................... 8- 7
storing buffer memory values................... 11- 4
Axis #1 to #4
error reset of .................................7- 6, 7, 10- 1
turning off the M code ON signal of ......... 10- 1
axis control monitor ..................................... 10-11
axis copy...................................................... 11-15
axis status.............................................7- 4, 10- 4
[B]
batch write .................................................... 11- 6
baud rate......................................................... 7- 1
block
copy.......................................................... 11-16
switching ............................................5- 1, 8-12
block start data
error (project) ............................................. 8-16
error (QD75) ............................................. 10- 2
initialization .............................................. 11-14
setting......................................................... 8-12
buffer memory
assigning to devices ................................. 11- 4
list............................................................. 11-37
[C]
cable .......................................................2- 3, 7- 3
check box........................................................ 5- 3
column clear ................................................ 11-13
COM port setting ............................................ 7- 1
command button............................................. 5- 3
comment
M code.........................................................8- 8
positioning data ...........................................8- 5
condition
of special start ...........................................8- 13
of trace start........................................11-31, 35
condition data..........................................8- 13, 14
connection setup.............................................7- 1
copy
of block start data.....................................11-16
of selection range......................................11- 8
on axis basis.............................................11-15
CPU
corresponding..............................................1- 1
storing buffer memory values into ............11- 4
type of..........................................................7- 2
CSV format positioning data file
reading of....................................................6-12
writing of .....................................................6-13
cut..................................................................11- 8
[D]
data initialization...........................................11-14
deletion
of project......................................................6- 8
of software package....................................4- 6
display
of status bar.................................................5- 1
of toolbar......................................................5- 1
drop-down menu.............................................5- 1
[E]
end
of application ..............................................4-11
of monitor...............................................10- 3, 4
of test........................................................10-21
entering present value to address...............11-28
check (QD75) ............................................10- 2
error
check (project)............................................8-16
code list.....................................................11-37
monitoring code.........................................10- 4
monitoring the history of............................10- 6